Some Basic question about Directaccess 2012

hi

recently deployed directaccess 2012 lab, , seemt ok.
clients able connect , connectivity ok, using ip-https, 2 interface behaind nat device

but have following questions:

- how force directaccess use inet proxy connect

- possible change ipv6 address on server, , how reflect on gop (client , server)

- added node , setup wnlb, clients failed , cannot connect, after troubleshooting, found dns64 not listening on port 53, in status seem green , fine.. dns64 service name , eventlog these services.

- recreate directaccess server, , server seem have new ipv6 address, ran djoin command again , include directaccess client policy, command ran success , user joined domain, da client policy not applied, clients member in directaccess client group 

hope have answer these

thanks

hi tony,

>>how force directaccess use inet proxy connect

you refer following link see how force da use proxy connect:

http://blogs.technet.com/b/tomshinder/archive/2010/03/30/more-on-directaccess-split-tunneling-and-force-tunneling.aspx

>>is possible change ipv6 address on server, , how reflect on gop (client , server)

servers must configured have static ipv6 address.

for reference:

https://support.microsoft.com/en-us/kb/3022362

>>what dns64 service name , eventlog these services

this link might helpful:

https://support.microsoft.com/en-us/kb/2859347

>>but da client policy not applied, clients member in directaccess client group 

when applied gpo, there prompts or logs?

you refer link below more help:

http://blogs.technet.com/b/tomshinder/archive/2010/03/13/uag-directaccess-group-policy-assignment-make-sure-the-right-policies-are-applied.aspx

warmly regards,

---

andy_pan

Windows Server  >  Windows Server 2012 General